Gheshlaghi- Azar N, Javad zadeh Haghighat A. Comparative Study on Degree of Root Canal Transportation Using Two Rotary Systems of Protaper, Profile 0.04 Taper and Hand K- Flexofiles in a In Vitro Condition. JGUMS 2004; 13 (51) :78-85
URL:
http://journal.gums.ac.ir/article-1-658-en.html
Abstract: (6395 Views)
Abstract
Introduction : Root canal preparation is one of the most important stages of endodontic treatment. It seems that rotary NiTi files are efficient instruments in root canal preparation.
Objective: This in vitro study was designed to assess the degree of canal transportation, resulting from instrumentation by a new rotary system (protaper) and to compare it with rotary profile 0.04 taper series 29 system and hand K- flexofiles in a Step- back manner.
Materials and Methods: Thirty six mesiobuccal canals of extracted human mandibular molars were instrumented in three groups by each of these methods respectively. Rotary systems were used in a crown- down manner according to the manufacture’s instruction, and stainless steel K- flexofiles were used in a conventional step- back method. Pre- and postoperative X- rays were taken, projected and degree of canal curvature was determined according to the schneider method. The difference of pre- and postoperative canal curvature was evaluated with ANOVA and student tests.
Results: The results of statistical analysis indicated that the degree of canal transportion in protaper group was statistically less than that in K- flexofile group that this difference was statistically significant(P<0.0001). There was no significant difference between two rotary groups(P<0.05).
Conclusion: On basis of the results obtained from this study, profile 0.04 taper and protaper systems were significantly less likely to change the canal curvature in comparison to stainless K- flexofiles, lie, the former methods compared to the latter one have better capabilities in maintaining the original shape of root canal
Review Paper:
Research |
Subject:
General Received: 2014/07/8 | Accepted: 2014/07/8 | Published: 2014/07/8