Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

---

Introduction: The Fabrication of dental prostheses for patients with Microstomia has been a problem for dentists for a long time. Microstomia often seen in patients who suffer from Scleroderma, burns, surgical removal of malignant lesions or congenital deformities. Patient’s Profile: This article describes a patient whose face was burned by hot water and it causes Microstomia. Partial removable prosthesis upper and lower by sectional Impertion technique was made for this patient. Initially, an impression of the mouth with conventional silicon, pour thin impression with dental Placter and at the end diagnostic cast was made, two sectional tray separately with acryl Cold cure, then was made the first final Impression with silicon rubber based. This impression Poured and separate the cast from the impression when the stone has set then second final impression was made, position the Cast made from the first impression in this impression, pour impression containing the Cast in dental Stone. Separate the cost from the impression after the stone has set. The Completed cast was prepared. Conclusion: If the patient will be comfort with this prosthesis we achieve to our aim.

Keywords: Sectional tray, Microstomia, Removable partial prosthesis

Full-Text [PDF 130 kb]   (2142 Downloads)    

Add your comments about this article : Your username or Email:

---